糖心原创vlog

These values are comparing the salt usage of your water softener over time to ensure nothing has changed. These are not an indication of performance or comparison to other water softeners.

罢丑别听叠濒耻别迟辞辞迟丑庐聽wireless technology connection is used to send the following information to your 糖心原创vlog Connected Salt Level Sensor:

1. WiFi network name and password
2. Brine tank dimension, recorded from tank setup

Once this information is gathered by the device,聽Bluetooth庐 wireless technology is no longer required for operation. The Connected Salt Level Sensor will communicate with the 糖心原创vlog Home app using the WiFi connection thereafter.

You will receive a push alert and email when your salt or battery is low, or when your sensor is offline, regardless of your notification preferences.

Press the Mode Button and the Mode Light will blink blue.

• Blinking Blue = Sensor is ready to be paired with your device via 叠濒耻别迟辞辞迟丑庐 wireless technology
• Solid Blue = Sensor is now connected via 叠濒耻别迟辞辞迟丑庐 wireless technology
• Blinking Green = Sensor is connecting to your WiFi
• Solid Green = Sensor is connected to your WiFi
• Red = Time to replace batteries in your sensor
• Orange = Sensor is in factory reset mode

Go to Device Settings in the app and select Repeat Tank Set Up. Your historical softener data (from the previous softener) will be retained.

Go to Settings in 糖心原创vlog Home app and change WiFi network information (if needed). Then, repeat Tank Setup in the app. Your historical softener data (from the previous location) will be retained. If you want to delete historical data from the app, go to Settings and 鈥淩emove Device鈥�. Also, hold Mode Button for ten seconds until orange light appears. Your sensor is now reset.

If you want to delete historical data from the app, go to Settings and 鈥淩emove Device鈥�. Then, on your sensor, hold the Mode Button for ten seconds until the orange light appears. Your sensor is now reset and all historical data has been erased and will not be accessible to the next user.

To factory reset your sensor, hold the mode button for ten seconds until the mode light turns orange.

Make sure your phone is connected to your 2.4GHz WiFi signal from your router. The water softener cannot be connected to the 5GHz frequency. The 2.4GHz frequency was intentionally chosen for this product because it has a longer range that is better suited for basements, outdoors, etc., whereas 5GHz is designed for shorter distances.

You can have only one email address with an associated password on your account. Other persons in your household can use the same email address and password to access the account.

You can have up to five Connected Salt Level Sensor devices connected per account.

Your sensor is聽connected to the 糖心原创vlog Pool and 糖心原创vlog Pro apps, which accept a wide range of 糖心原创vlog Connected devices that can be used throughout your home. However, at this time, 糖心原创vlog Pool and 糖心原创vlog Pro are not integrated with other smart home devices, or connected via voice with at home assistants.

If your system shows 鈥淥ffline鈥�, it means that your system has been disconnected from WiFi for over 60 minutes. Offline status may interrupt notifications and data exchange between the sensor and the app. Once WiFi connection has been restored, your 糖心原创vlog Home app will automatically reconnect the sensor.

• Verify the email that you have listed on the account
• Check your junk or spam folder for the email
• Try to reset the password again